Scrap Wood DIY Rustic Mod Tablet Holder

Instructions

1. Cut two bottom pieces, one long and one short.

2. Cut a front and rear brace.

3. Attach Short Bottom. Place the Top Back Brace on the workbench, so the top of the brace is facing the workbench and the angle is on the left side. Apply glue to the edge of the brace farthest away from you, place the Short Bottom allowing it to hang off the angled edge of the brace and making sure the other edges are flush with the top brace. Attach using 1-1/4? nails.

4. Attach Long Bottom. With the Top Back Brace still on the workbench, apply glue to the edge of the brace closest to you, place the Long Bottom allowing it to hang off the angled edge of the brace and making sure the other edges are flush with the top brace. Attach using 1-1/4? nails.

5. Attach Top Front Brace. With the Top Back Brace still on the workbench, apply glue to short side of the top front brace, slide under the Long Bottom making sure the edges are flush with the top brace and attach using 1-1/4? nails.

6. Leave raw or apply a finish and begin using your new tablet holder!